Expert Concrete Basement Floor Installation in Mississauga

A basement floor is only as good as what's under it. We pour level, moisture-resistant slabs over proper drainage and a vapour barrier — and we're on-site within days of your free assessment.

Request Your Free Inspection

DrainCom is the

No. 1 Rated

choice for licensed and insured Concrete Basement Floor Installation in Mississauga, Canada.

A cracked, sinking, or damp basement floor rarely stays cosmetic. What starts as a hairline crack points to moisture or a failed subgrade, and it only spreads with each freeze-thaw season.

At DrainCom, we’ve installed and repaired concrete basement floors for over 20 years. We’re foundation and basement specialists — not a general contractor who pours the occasional floor.

Slab removal, sub-slab drainage, vapour barriers, rough-in plumbing, sump pits, new pours, basement lowering — we cover all of it. Licensed technicians, industry-grade materials, and a 25-year transferable warranty on qualifying work.

⚠️ Water in your basement right now? Call 905-238-6800 or 416-989-5757 — we offer emergency basement and foundation service across the GTA.

The Homeowners Who Finally Got a Floor That Lasts

A cracked, sinking, or damp basement floor rarely stays cosmetic — and patching it never lasts. The homeowners who call us want it fixed once, properly, from the subgrade up. These are the ones now standing on a floor built to last. Over 20 years, we’ve earned a 9.9 out of 10 on HomeStars across more than 800 reviews and worked on foundations and floors in more than 20,000 homes across the GTA.

Removal, Drainage, Pour. Here's the Whole Job

The right scope depends on what’s happening under your floor. We figure that out first, then handle every step below with one crew.

Freshly poured concrete strip and drain grate during a basement concrete floor installation

Old Concrete Slab Removal and Disposal

We break up the existing slab, haul it away, and inspect the subgrade and drainage the moment the concrete is out. That open floor is when underlying problems are easiest to spot and correct.

Interior Waterproofing Before the Floor Pour

If water is coming through the foundation walls or footings, we handle interior basement waterproofing before the new floor goes down. Pour over an unaddressed water source and the problem simply resurfaces beneath your fresh slab.

Underground Drain Replacement

Damaged, collapsed, or undersized drainage beneath the slab gets replaced before the pour. This is the step that stops a floor from sinking or cracking all over again a few years later.

Rough-in Plumbing Installation

New plumbing — bathroom rough-ins, floor drains, laundry connections — goes in and gets pressure-tested while the subgrade is open, before the concrete covers it for good.

Sump Pump Pit and System Integration

We install sump pump pit as part of the floor project, tying it into the new drainage layout so groundwater is managed correctly from day one.

Backwater Valve Installation

We install a backwater valve on the main drain line while the floor is open, protecting your home from sewer backups without a separate excavation down the road.

New Concrete Floor Installation

The new slab is poured to proper thickness over a graded, reinforced subgrade with a vapour barrier underneath, then finished smooth and ready for whatever flooring you’ve got planned.

Basement Lowering with New Concrete Floor

For basements being lowered to gain ceiling height, we underpin the foundation for structural support, excavate to the new depth, and pour the floor at the lower elevation.

Turn That Basement Into Real Living Space

A solid, dry, level floor is the foundation for everything you want to do with the space downstairs. Here’s what it unlocks:

  • Finish the basement — lay any flooring you like over a level, moisture-resistant slab without worrying about buckling later.
  • Add a legal apartment — a lowered floor with proper ceiling height is the base for a legal secondary suite where permitted.
  • Build a bathroom or laundry — rough-in plumbing goes in cleanly while the subgrade is open.
  • Gain real headroom — basement lowering turns a cramped cellar into full-height living space.
  • Protect against moisture — the vapour barrier and drainage under the slab keep dampness from creeping up.
  • Add lasting value — a sound floor and added square footage are a genuine selling point at resale.

What Concrete Basement Floor Installation Costs in Mississauga

Your cost depends on the finish you want, the condition of the subgrade, and whether drainage or excavation work is needed. Here’s a realistic guide for Mississauga homeowners.

Project Type Typical Cost What It Usually Includes
Basic unfinished concrete floor $2 – $6 per sq ft Standard pour or replacement with minimal finishing
More detailed basement floor pour $4 – $25 per sq ft Extra reinforcement, complexity, and site conditions
Polished concrete finish $4 – $12 per sq ft Smoother finish, more labour, surface polishing
Stained concrete finish $3 – $10 per sq ft Decorative colour treatment on a new or existing slab
Epoxy-coated concrete floor $5 – $13 per sq ft Protective coating for durability and moisture resistance
Decorative / stamped concrete $8 – $20+ per sq ft More design work and finishing labour

These are approximate ranges for typical residential projects. After your free on-site assessment, you get a detailed written quote — no hidden fees, no surprise charges once work begins.

Basement lowering with underpinning is a larger, engineered project priced separately. Across the GTA, full basement lowering generally runs a few hundred dollars per square foot once structural work, drainage, and the new slab are included. We’ll break it all down for you before anything starts.

Why One Floor Costs More Than the Next

Wire mesh and gravel base beside a wet slab pour during a concrete basement floor installation

Basement size and access

Larger floors, and basements where equipment can’t reach easily, take more labour and time.

Excavation requirements

Floor lowering or underpinning adds real cost because of the structural support work and soil removal involved.

Underlying drainage issues

If water beneath the slab caused the original failure, drainage correction has to happen before the new pour — it adds cost, but it prevents a repeat.

Finishing requirements

Polished, stained, or epoxy-ready finishes cost more than a standard broom finish.

Signs the Slab Has Failed, Not Just Cracked

Your floor usually warns you before it fails outright. Spot any of these? It’s worth an inspection.

concrete-slab

These point to a slab that’s failed structurally or is being compromised by moisture from below. Patching the surface won’t fix the root cause.

No Guesswork, Every Step, Subgrade to Finish

Assessment

We inspect the existing floor, find the cause of the failure, and check for drainage or soil issues underneath.

Quote

You get a detailed written quote before any work starts, covering scope, materials, and timeline.

Demolition

We break up and remove the old slab, along with any compromised subgrade material.

Waterproofing and drainage correction

Interior basement waterproofing and underground drain replacement are done if needed, before the new pour.

Rough-ins

Plumbing, the sump pump pit, and a backwater valve are installed and tested while the subgrade is open.

Grading and reinforcement

The subgrade is compacted and graded, then reinforced with rebar or wire mesh.

Vapour barrier

A moisture barrier goes down to block water migration up from the soil.

Pour and finish

Concrete is poured to proper thickness and finished smooth, level, and ready for your flooring.

Curing and final inspection

The floor cures fully before the final walkthrough and sign-off.

Why What's Under the Slab Matters Most

A concrete floor poured without fixing the drainage, or without proper reinforcement, often fails again within a few years — cracking, settling, or letting moisture right back into your basement.

A floor poured correctly the first time, with the original cause corrected, is built to last the life of your home. The gap between a quick patch and a proper installation is small next to the cost of redoing the whole thing in five years.

Here’s what “done right” looks like underneath: interior weeping tile sloped to the sump pit, four to six inches of clear gravel, a vapour barrier, then a four-inch reinforced slab on top. That build-up is what keeps a Mississauga basement floor dry over our heavy clay soil and high water table.

Pour, Repair, or Level? Here's How to Tell.

Not every floor needs to be torn out. Here’s how the three options compare.

OptionScopeBest ForOutcome
New PourFull replacementFailed, cracked, or settling slabLong-term, permanent
Crack / Spall RepairTargeted repairIsolated cracking or surface spallingMedium-term, depends on cause
Self-Levelling CompoundSurface correctionUneven but structurally sound floorCosmetic only — doesn’t fix structural issues

The right call depends on whether you’ve got a structural or drainage problem versus a surface-level one. Our assessment sorts that out before we recommend anything.

Foundation and Basement Specialists, Not General Contractors

  • 20+ years serving Mississauga, focused on foundation and basement work, not general contracting.
  • Licensed technicians experienced in both new pours and structural floor repair.
  • We diagnose the cause of floor failure before recommending a fix.
  • Drainage correction is included when needed, never sold back to you as a surprise upsell.
  • Transparent written quotes before work starts — no surprise costs.
  • Clean, professional job sites with minimal disruption to your home, plus a 25-year transferable warranty on qualifying work.
Request Your Free Inspection

Top Rated Waterproofers just a call away!

Business Hour:
Monday to Friday: 8a.m -9p.m
Saturday and Sunday: 9a.m – 2p.m

Concrete Floor Questions, Answered Straight

Most standard floor replacements take three to five days, including demolition, pour, and initial curing. Full cure time before heavy flooring goes down is typically 28 days.

If water beneath the slab caused the original failure, yes. Pouring over an unresolved drainage issue leads to the same problem coming back within a few years.

Yes. This requires underpinning the foundation for structural support before we excavate and pour at the lower elevation. It’s a larger project that needs engineering review in most cases.

Self-levelling compound corrects surface unevenness on a structurally sound floor. A full replacement is needed when the slab itself is cracked, settling, or compromised by moisture.

Standard residential basement floors are typically four inches thick, reinforced with wire mesh or rebar depending on the load.

A properly installed vapour barrier beneath the slab greatly reduces moisture migration. But if the source is a high water table or a drainage issue, that has to be corrected separately for full protection.

Yes. Workmanship and material warranties are provided and spelled out in your written quote, and qualifying work carries our 25-year transferable warranty.

Let's Pour You a Floor Built to Last

If your basement floor is cracked, sinking, damp, or just past its prime, we’ll find out why before we pour. Our team will assess the slab, check the drainage underneath, and recommend the right fix for your home.

You’ll get honest advice, a detailed written estimate, and zero pressure to move forward.

Round Out the Job While the Floor's Open

A concrete floor project often ties into the rest of your basement’s water defence. If your assessment turns up more, we handle it all with one crew:

basement waterproofing Service Toronto GTA
Request a Free Estimate
905-238-6800